HALL 10-1940-BWT007U IN Design by Nahtrang design TECHNICAL CHARACTERISTICS The photograph may not match the reference exactly. Please read the product description to identify the finish. Type: Table lamp IP Protection degrees: IP20 Light source 1: Bulb specified at the product label 3 x E26 18W Location: DRY Total power consumption (W): 54 Voltage / Frequency: 120V/60Hz Warranty: 2 Units per box: 1 Net Weight (Lb): 9.78 EAN Code: 8435381437190 Stability: 15º MATERIALS / FINISHES Download photometric file .ldt /.ies Structure material: Steel Diffuser material: Fabric shade Methacrylate Structure finish: Diffuser finish: Matt white LEDS-C4 reserves the right to make the necessary technical changes they deem adequate, in order to improve the features of the product. Please consult the sales team to clarify any doubt. White Tinted (+34) 973 468 100 [email protected] www.leds-c4.com LEDS, C4 S.A. CIF/VAT: A-59.410.910 C/ Afueras s/n -TORA- 25750 (LLEIDA) SPAIN TEL: 34 (73) 46 81 02 FAX: 34 (73) 46 81 06 SHEET: 1/1 EDITION: 01 REF: 10-1940U FIGURE Nº 1. UNPACK THE FIXTURE: CHECK THE CONTENTS OF THE BOX. YOU SHOULD RECEIVE: FIGURE Nº 1. DÉBALLER LE PLAFONIER: VÉRIFIER LE CONTENU DU CARTON, VOUS DEVEZ RECEVOIR: 2 3 4 5 6 I/0 CAUTION: ATTENTION: "Warning", "This product is to be installed by a qualified electrician only." "Suitable for dry locations only" "Attention", le raccordement électrique sera effectué par un téchnicien électricien qualifié" "Adéquat seulement en lieux secs." CAUTION: 1.- Wrong lighting installation can be dangerous for your safety. 2.- Before starting, disconnect the power by turning off the general switch of the electric installation. 3.- Install light bulbs (not provided) that must not exceed markings on the fixture. 4.- To change the bulbs, disconnect the power by turning off the general switch and wait for the bulbs cool down. INSTALLATION: 1.- Assembly according to the attached instructions. ELECTRICAL CONNECTIONS: ATTENTION: 1. Une mauvaise installation peut compromettre votre sécurité. 2. Déconnecter la tension du réseau d'alimentation avant de réaliser toute opération. 3. Installer les ampoules (non fournies), ne pas utiliser d'ampoules d'un autre type ou d'une puissance supérieure à celle indiquée sur l'étiquette de la lampe. 4. Pour changer les ampoules, déconnecter la tension du réseau d'alimention et laisser refroider les ampoules. INSTALLATION: 1. Suivre le mode d’emploi quand vous faites le montage. RACCORDEMENTS ÉLECTRIQUES: