Manufacturing Process and Method Pratical Work

10/07/2023
PRACTICAL
REPORT
Mr SAWADOGO

Contents
Project title: TIGHTENING SUPPLY
INTRODUCTION
During our second year of a license in mechanical engineering, we had to work in a group
of 7 people on a design project for a clamping vice. First of all, in this report, we will present the
objectives of this project, the list of materials and machines that we had used, the range of
machining that we had established to facilitate our work, as well as the difficulties encountered.
I. Objectives of the practical work report
The aim of this project is to enable us to put into practice what we have been taught during
the course about manufacturing techniques, dimensioning and the use of different machines and
tools. This will enable us to make the link between theory and practice.
II. List of equipment and machinery used
• Drill
• Electric saw
• Grinding wheel
• Clamping vice
• Vernier caliper
• Square
• Meter
• Welding unit
• Tapping tools

Materials used
• Angle bracket (255mm)
• Flat iron bar (234mm)
• Rod (180mm)
III. Hypothesis
To enable us to carry out our work properly, we had drawn up a machining range for
each part to enable the part to be handled properly during machining.
We also had to calculate the speed required for drilling.
N=(1000*Vc) / (π*D)
Machining range

Part Guid
OFFICE OF METHODS
Element:
Symbols:
Support:
Centering:
Tightening:
Material : S235
N0.
Ph.
Designation of phases,
Sub-phases and Operations
Machine:
Sketch of the part at its various stages of machining
10
Crude control
Checked dimensions and
specifications
Length=200
large=40
Pocket tape
20
Drilling
Plan support 3N (1, 2, 3)
Linear support 2N (4, 5)
Punctual support 1N (6)
Drill
Drill in ARS:
Calibre 07.
Pocket tape
Square
Calibre tap 08
30
Chamfering
Plan support 3N (1, 2, 3)
Linear support 2N (4, 5)
Punctual support 1N (6)
Rectification
40
Final control
Dimenssionment:
L=200mm
l=40mm
Diameter: ø8
Chamfering angel: α=65O
Square
Pocket tape
Protractor

Part Guid
OFFICE OF METHODS
Element :
Symbols:
Support :
Centering:
Tightening:
Material : S235
N0.
Ph.
Designation of phases,
Sub-phases and Operations
Machine :
Sketch of the part at its various
stages of machining
10
Crude control
Checked dimensions and
specifications: L=40, l=14
Pocket tape
Drilling machine,
Grinding machine.
20
Drilling, Threading
Plan support 3N (1, 2, 3)
Linear support 2N (4, 5)
Punctual support 1N (6)
Drill
Drill in ARS
Ø5
Threading tool
(Tap)
30
Drilling, Threading
Plan support 3N (1, 2, 3)
Linear support 2N (4, 5)
Punctual support 1N (6)
Drill
Drill in ARS
Ø5
Threading tool
(Tap)
40
Chamfering
Plan support 3N (1, 2, 3)
Linear support 2N (4, 5)
Punctual support 1N (6)
Disc wheel
Grinding machine
Square
50
Final control
L:40mm, l:14mm
Diameter: M5
Chamfered